Gendral Civil Engineering

Do’s & Do not’s For Reinforcement Detailing

Do’s & Do not’s For Reinforcement Detailing DO’S-GENERAL Reinforcement Detailing Prepare drawings properly & accurately if possible label each bar and show its shape for clarity. 1.Cross section of retaining wall which collapsed immediately after placing

Reinforcement

Tolerance on Placing of Reinforcement

Tolerance on Placing of Reinforcement Unless otherwise specified by the Engineer-in-charge, reinforcement shall be placed within the following tolerances: Tolerance in spacing a) For effective depth, 200 mm or less + 10 mm b) For

Reinforcement

Development length and Lap length

Development length and Lap length  addresses the length of the bar needed to transfer the stresses to the other bar whereas Development length addresses the length of the bar needed to transfer the stresses to the

Reinforcement

Doubly Reinforced Beam

To understand the term doubly reinforced section, one should have knowledge about design of beams and moment of resistance. The main consideration of beam is moment of resistance. We design the beams such that it

Reinforcement

One way slab Reinforcement Details

One way Slab are slab in which one side is very large compared to the other one. Generally if one side is more than double of the other one, the slab will be one way.